HB Sauter Mechanical Shore Hardness Durometer
The HB mechanical shore hardness or durometer is designed to measure the hardness on various products, comes in 3 hardness types Shore A, C and D each unit is supplied in a wooden carrying case for protection of the product whilst not being used.
- Shore A is for use on products like rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar materials.
- Shore C is for use on products such as foam, sponge or similar materials
- Shore D is for use on products such as plastics, formica, epoxies, plexiglass and similar materials
Particularly recommended for Internal comparison Measurement. Standard Calibrations e.g. to DIN 53505 are often not possible because of very narrow standard tolerances.
No Calibration Certificates are offered for the Gauge, they are only possible on the calibration plates found under accessories.
|Range Listing Note||Measuring Range: : 0 - 100H|
Click product name for more information:
12 Month Warranty
Typical application: measurement of penetration (Shore)
Particularly recommended for internal comparison measurement. Standard calibrations e. g. to DIN 53505 are often not possible because of very narrow standard tolerances
Shore A rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar material
Shore D plastics, formica, epoxides, plexiglass etc.
Shore A0 foam, sponge etc.
Max mode: Holds the maximum value in the display
Point mode: Shows one instant value
Can be attached to the test stands SAUTER TI-A0 (for Shore A and A0), TI-D. (for Shore D)
Delivered in a wooden carrying case